Donnerstag, 26. Juli 2012

Gearbox Output Shaft

The gearbox output shaft was not running in center. The ball bearing shaft sitting was too small. The shaft had to be built-up by chrome plating. It took four weeks...
...but finally the shaft its running perfect.

2 Kommentare:

  1. this is a very unusual failure.......

    AntwortenLöschen
  2. Yes. I think the brake disk got a side hit and this causes the shaft problem.
    While I was braking the car, I had very bad vibrations. The workshop has also turned down 1/10 mm from each side of the brake disk.

    AntwortenLöschen